|
I am trying to get my NIC's setup. I have two
of them. They are both Linksys EtherFast 10/100 LAN Cards Version
2. I have an alias command for both of them in conf.modules which is
alias eth0 tulip and alias eth1 tulip. Tulip is the driver that they
require. I also added this line to lilo.conf file -- append =
"ether=0,0,eth1" When I boot up, Lilo says that it is trying to start eth0
and eth1 and then it says that initialization failed. Any other ideas on
getting these setup.
thanks...
KG [ iMa '99 ]
|